Extreme Networks AP-7532 - CE Marking and European Economic Area (EEA); Japan VCCI

Regulatory Information
AP-7532 Access Point Installation Guide 35
radioélectriqueà l'intention des autres utilisateurs, il faut choisir le type d'antenne et son
gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas
l'intensité nécessaire àl'établissement d'une communication satisfaisante.
In compliance with respective local regulatory law, AP software provides professional
installers the option to configure the antenna type and antenna gain for approved antennas.
This radio transmitter (AP-7532, AP-7532I) has been approved by Industry Canada to
operate with the antenna types listed below and having a maximum gain allowable and the
impedance required for each type of antenna. The antenna types not included in this list, or
whose gain is higher than the maximum gain indicates, are strictly prohibited for the
operation of the transmitter.
Refer to “AP-7532 Antennas” on page 4 for a listing of the 2.4 GHz and 5 GHz antennas
initially approved for use with AP-7532 and AP7532I Access Points.
Le présent émetteur radio (AP-7532, AP-7532I) a été approuvé par Industrie Canada pour
fonctionner avec les types d'antenne énumérés ci-dessous et ayant un gain admissible
maximal et l'impédance requise pour chaque type d'antenne. Les types d'antenne non
inclus dans cette liste ou dont le gain est supérieur au gain maximal indiqué, sont
strictement interdits pour l'exploitation de l'émetteur.
CE Marking and European Economic Area (EEA)
The use of 2.4GHz RLAN’s, for use through the EEA, have the following restrictions:
• Maximum radiated transmit power of 100 mW EIRP in the frequency range 2.400 -
2.4835 GHz.
Statement of Compliance
Extreme Networks hereby, declares that this device is in compliance with the essential
requirements and other relevant provisions of Directive 2014/53/EU. See “Declaration of
Conformity in Languages of the European Community” on page 29.
Japan (VCCI) - Voluntary Control Council for
Interference
Class B ITE
Warning
This is a Class B product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.