Extreme Networks AP-7532 - Power Supply Requirements; Radio Frequency Interference - FCC

Regulatory Information
AP-7532 Access Point Installation Guide 33
To satisfy US and Canadian RF exposure requirements, a transmitting device must operate
with a minimum separation distance of 30cm or more from a person's body.
Pour satisfaire aux exigences Américaines et Canadiennes d'exposition aux radiofréquences,
un dispositif de transmission doit fonctionner avec une distance de séparation minimale de
30cm ou plus de corps d'une personne.
Radiation Exposure Statement
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance
30cm between the radiator and your body.
NOTE IMPORTANTE: (Pour l'utilisation de dispositifs mobiles)
Déclaration d'exposition aux radiations:
Cet équipement est conforme aux limites d'exposition aux rayonnements IC établies pour
un environnement non contrôlé. Cet équipement doit être installé et utilisé avec un
minimum de 30cm de distance entre la source de rayonnement et votre corps.
Remote and Standalone Antenna Configurations
To comply with FCC RF exposure requirements, Antennas that are mounted externally must
be professionally installed at a fixed location and operate with a minimum distance of 30cm
from all persons.
To comply with FCC Antenna requirements, the Antenna must be adjusted such that the RF
emission lobes are below 30 degrees elevation.
Power Supply
This device must be powered from a 802.3af or 802.3at compliant power source which has
been certified by the appropriate agencies, or by an approved UL LISTED ITE (IEC/EN
60950-1, LPS/SELV) power supply with electrical ratings: Output 12 Vdc, min 1.25 A or 48
Vdc min 0.375 A (POE), with a recommended ambient temperature greater than 40
degrees C. Use of alternative power supply will invalidate any approvals given to this unit
and may be dangerous.
Radio Frequency Interference Requirements—FCC
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.