Order Code Description Region
AA0020065E6 POWER CORD 2.5M IEC C13 TO CEI 23-16 Italy
AA0020066E6 POWER CORD 2.5M IEC C13 TO GB 2099.1-1996 China
AA0020067E6 POWER CORD 2.5M IEC C13 TO BS-546/SANS164-1 India and South Africa
AA0020068E6 POWER CORD 2.5M IEC C13 TO AS 3112 Australia
AA0020069E6 POWER CORD 2.5M IEC C13 TO JIS 8303 Japan
AA0020101-E6 POWER CORD 2.5M IEC C13 TO NBR 14136 (IEC
60906-1)
Brazil
AA0020104-E6 POWER CORD 2.5M IEC C13 TO SEV 1011 Switzerland
AA0020107-E6 POWER CORD 2.5M IEC C13 TO SI-32 Israel
Console port pin assignments
Console port establishes a management terminal connection to the switch.
You can use an RJ-45 to DB-9 cable to connect the switch console port to your management
terminal. Extreme Networks recommends you use the RJ-45. Alternatively a DB-9 to RJ-45 adapter
or other suitable console cables can be used - the maximum length of a console cable is 25 feet (8.3
meters). The following table describes the RJ-45 console port pin-out information. You can use the
pin-out information to verify or create a console cable for use with your maintenance terminal.
Table 7: Console port pin assignments
Connector
Pin Number Signal
1 Ready to send (RTS) — optional,
can swap or link with pin 8
2 Data terminal ready (DTR) —
optional, can swap or link with pin
3 Transmit data (TXD) — mandatory
4 Carrier detect (DCD) — optional
5 Ground (GND) — mandatory
6 Receive data (RXD) — mandatory
7 Data set ready (DSR) — optional,
can swap or link with pin 1
8 Clear to send (CTS) — optional,
can swap or link with pin 1
Installing the ERS 3500 Series
December 2017 Installing Ethernet Routing Switch 3500 Series 44
To Next Page
Loading...
