Figure 18: Setting Floor Plan Scale
•
Click to draw a doorway.
1 Draw a line to represent a doorway.
2 Click Apply.
•
Click
to draw the floor length. Draw a line on the map that represents an actual physical
distance. On the map, double-click the beginning and ending points of the line. The length of the
wall (based on the set scale) is displayed on the map.
Drawing Boundary Walls
Draw the outside boundary of the building. The area within the boundary is used to determine device
location and coverage. The area outside the boundary is ignored.
To draw boundary lines:
1 Go to Configure > Sites. Add a new site or select a site and click Floor Plans tab.
2 Click Draw Tools to display floor plan tools.
3 To anchor the beginning of the boundary line, click a corner of the outside boundary.
4 Click each corner to anchor the line. The drawing line zigzags across the image as you anchor each
corner.
Note
If you make a mistake, you can click to edit the boundary or click to delete the
boundary and start over.
5 When you finish the boundary, double-click the last corner to disable the pen tool.
Next, go to Drawing Inner Walls on page 103.
Configure
ExtremeCloud Appliance User Guide for version 4.36.03 102
To Next Page
Loading...
