4 Navigate to the background image file.
The following image file formats are supported: .jpg, .png. svg
Note
.svg is not supported with Internet Explorer version 11.
5 Click Open.
The background image is displayed.
6 Click Save to save the floor plan.
To remove the image: display the image on the map and click the Floor Image delete icon . Then,
click OK.
Next, go to Setting Floor Plan Scale on page 101
Setting Floor Plan Scale
Scale the floor plan based on actual floor plan measurements. You can scale a floor plan using a
doorway measurement, or by representing any known distance in the room.
Note
The following procedure corresponds to the callout numbers in Figure 18 on page 102
To scale a floor plan:
1 Display the floor plan.
Go to Configure > Sites. Add a new site or select a site and click Floor Plans tab.
2 Select a floor plan to edit from the drop-down list.
3 Under Scale / Measures:
•
Click to enter a known length in the Length field that displays.
1 Draw the physical line on the map.
2 In the field, enter a numeric value that represents the physical distance and that corresponds
to the line drawing. The pixel value for the line drawing displays.
3 Select the units of measure and click Apply.
In the following figure, the floor plan scale is set (65px = 20 Meters).
Configure
ExtremeCloud Appliance User Guide for version 4.36.03 101
To Next Page
Loading...
