Extreme Networks Summit 200-24 - Switch Installation; Determining the Switch Location

Evaluating and Meeting Cable Requirements
Consolidated "e" Series Hardware Installation Guide 27
Figure 1: Properly secured rack (SPG_007 redraw with e series in the rack)
Brace open distribution racks if the channel thickness is less than 1/4 inch (6.4 mm).
Evaluating and Meeting Cable Requirements
This section addresses requirements for the that cable you should use when installing your network
equipment. It includes:
• Cabling Standards
• Cable Labeling and Record Keeping
• Installing Cable
• RJ-45 Connector Jackets
• Radio Frequency Interference
Cabling Standards
We recommend using the BICSI (Building Industry Consulting Service International) RCDD (Registered
Communications Distribution Designer), which is globally recognized as a standard in site planning and
cabling. For information, go to http://www.bicsi.org
SPG_00
7
Secure to floor
with 3/8 inch lag screws or bolts