Internal 600 Watt Power Supply (15412)
Consolidated "e" Series Hardware Installation Guide 83
Figure 27: Attaching the retaining bracket using spacers
4 Connect the power cable to the switch
CAUTION
Do not connect the power cable to the power source at this time.
5 For power supplies with permanently attached standoffs, attach the retaining bracket to the power
supply using the bracket screws, as shown in Figure 26. For power supplies without permanently
attached standoffs, use the supplied spacers between the bracket and the power supply, as shown in
Figure 27.
6 Tighten the retaining bracket screw.
If your switch has two power supplies, align the retaining brackets, as shown in Figure 28, so that
the retaining bracket screws do not interfere with each other.
7 Connect the power cable to the power source.
8 Set the power supply switch to the ON position.
To Next Page
Loading...
