AVT 200HD Tuner • Remote Configuration and Control 57
X6)
= Subnet mask nnn.nnn.nnn.nnn
(Leading zeros in each of the four fields are optional
for setting values and are suppressed in returned
values.
Default = 255.255.0.0
X6!
= Message length, delimiter value, nL = Length of message to be received
or byte count (via the serial port). nD = Delimiter value
(This parameter is optional.) n = byte count (1 through 32767; default is 0)
Placed in front of the parameter (nD or nL)
X6@
= Verbose mode 0 = clear or none (default for Telnet connection)
1 = verbose mode (default for RS-232 connection)
2 = tagged responses for queries
3 = verbose mode and tagged responses for queries
NOTE: If tagged responses is enabled (modes 2 and 3), all read commands return the constant
string and the value as the set command does (for example, the read name command
E
CN
}
returns Ipn•
X5@]
).
X6#
= Priority status for receiving timeouts 1 = use Send data string parameters (if they
exist) (default).
2 = use Configure receive timeout command
parameters instead.
X6$
= IP address converted into a single
32-bit number
Example: 10.13.0.254 becomes
(10*256*256*256) + (13*256*256) +
0*2456) + 254, which becomes (167,772,160 + 851,9678 + 254, which equals
68,624,382.
X6%
= Baud rate 9600 (default), 19200, 38400, 115200
X6^
= Parity Odd, Even, None (default), Mark, Space (Only the
first letter is required.)
X6&
= Data bits 7, 8 (default)
X6*
= Stop bits 1 (default), 2
X6(
= Port type 0 = RS-232 (default)
X7)
= Flow control Hardware, Software, None (default) (Only the first
letter is required.)
X7!
= Data pacing Specified in milliseconds between bytes:
0000 through 1000 (default = 0 ms)
X7@
= Password 12 characters maximum
NOTE: The following characters are invalid in passwords:
{space} + ~ , @ = ` [ ] { } < > ‘ ’ “ ” ; : | \ and ?.
X7#
= Daylight saving time 0 = off or ignore
1 = USA (Begins second Sunday in March and ends rst
Sunday in November.)
2 = Europe (Begins last Sunday in March and ends last
Sunday in October.)
3 = Brazil (Begins third Sunday in October and ends
third Sunday in February.)
X7$
= Event number 0 through 99 (event must be running)
X7%
= Event buffer 0 = receive
1 = unified
2 = data
3 = NVRAM
X7^
= Event buffer offset 0 through maximum buffer size
To Next Page
Loading...