Extron electronics DMP 64 - Page 113

Command ASCII command
(host to device)
Response
(device to host)
Additional description
Protected configuration
NOTE: The DMP64 can save and recall a Personal Identification Number (PIN)-protected configuration, including
mic mixes, parameters, variables, and values (with the exception of the device’s IP address). The protected
configuration is useful to establish the DMP64 in a known state, either as a troubleshooting tool or as a
baseline configuration.
Save the configuration
E
S
X7)
PCFG
}
PcfgS
]
Save the configuration to the
protected memory location.
Recall the configuration
E
RPCFG
}
PcfgR
]
Recall the protected
configuration
Change the PIN
E
P
X7)
old
*
X7)
new
PCFG
}
PcfgP
X7)
new
]
Overwrite the old PIN
(
X7)
old
) with the new one (
X7)
new
).
Query configuration saved
status
E
QPCFG
} X7!]
NOTES:
X7)
= Personal Identification Number (PIN) Four numeric digits, default = 0000
X7!
= Protected configuration status 0 = no protected configuration saved
1 = protected configuration saved
Command and Response Table for DSP SIS Commands (continued)
Table 1.
X6)
— Level Control and Mix-point Selection
NOTE: Circled numbers refer to DSP Processors Addressable by
SIS Commands on page103.
a
Input Gain Control
X6)
b
Pre-mixer Gain
X6)
Mic/Line Input 1
40000
Mic/Line Input 1
40100
Mic/Line Input 2
40001
Mic/Line Input 2
40101
Mic/Line Input 3
40002
Mic/Line Input 3
40102
Mic/Line Input 4
40003
Mic/Line Input 4
40103
Mic/Line Input 5
40004
Mic/Line Input 5
40104
Mic/Line Input 6
40005
Mic/Line Input 6
40105
e
Volume Out Control
X6)
Output 1
60000
Output 2
60001
Output 3
60002
Output 4
60003
f
Virtual Return Gain
X6)
Output A
50000
Output B
50001
Output C
50002
Output D
50003
DMP64 • SIS Programming and Control 107