Extron electronics DMP 64 - DMP Software; Software Control

DMPSoftware
This section describes the control software for the DMP64, including:
• Software Control
• Embedded Web Pages
• Windows-based Program Control
• DSP Configurator Program Basics
• Audio level, Mix-point, Processing Blocks, and Signal Chains
• Mic/Line Input Signal Controls
• Ducker Tutorials
• Line Output Channels
• Virtual Bus Returns
• Primary Mix Matrix
• Secondary Mix Matrix
• Group Masters
• Digital I/O Ports
• Emulate Mode and Live Mode
• Presets
• Protected Configuration
• DSP Configurator Windows Menus
• Optimizing Audio Levels
Software Control
The DMP64 can be controlled using the DSPConfigurator software, SIS commands
through hyper terminal or DataViewer, or using embedded WebPages. IPLink functions
will be available through network connection including global viewer functionality.
The DMP64 has the following connection options:
• RS-232 — One single stack 3-pole, 3.5 mm captive screw connector is used for
bi-directional RS-232 (±5 V) serial control.
See Rear Panel Features and Cabling on page5, for additional details on
connecting the RS-232 port.
• LAN — 10 Mbps, 100 Mbps, halfduplex, full duplex connections are supported. Two
LEDs indicate connection and activity status. The device has the following default
Ethernet configurations:
IP Address: 192.168.254.254 Default Gateway: 0.0.0.0
Subnet Mask: 255.255.0.0 DHCP: OFF
See Rear Panel Features and Cabling on page5, and Connection Options
on page92 for additional details on connecting the LAN.
• USB 2.0 — A Mini B-type USB connector located on the front panel provides
high-speed USB 2.0 connectivity to a host computer, backward compatible to 1.0.
DMP64 • Software Control 14