Extron electronics DMP 64 - DSP Configurator Program Basics; Starting the Program; Using the Program

3. When the installer has completed the installation of the USB drivers, the following
screen appears (see figure 14):
Figure 14. Successful USB Driver Installation
4. Click Finish.
USB driver installation is complete.
DSP Configurator Program Basics
Starting the Program
NOTE: Extron recommends connection via the Ethernet LAN port for running the
DSPConfigurator program.
To run the DSP Configurator Program, click
Start > Programs > Extron Electronics > DSP Configurator > DSP
Configurator.
The DSP Configurator program starts in Emulate mode (see figure 15, next page). Also
(see Emulate Mode and Live Mode on page76) for details of mode operation.
Using the Program
In Emulate mode, audio parameters can be selected, then transferred to the DMP64
by switching to Live mode (while connected to a DMP64). Audio settings can also be
tailored while connected to the DMP64 which allows real-time auditioning of the audio
output as adjustments are made (see Emulate Mode and Live Mode on page76).
DMP64 • Software Control 18