4. To highlight another element or group of elements, repeat steps 2 and 3 as required.
5. To cut or copy, press the <Ctrl+X> or <Ctrl+C> key combination.
6. To save a preset, press <Alt +T>, <Right Arrow>, <Down Arrow>, then <Enter>,
(see figure 57 below
)
.
7. The Save a Preset dialog box appears.
a. <Tab> to highlight the Preset Number field and type a specific number.
b. <Tab> to highlight the Preset Name field and type a name.
NOTE: Unless entering a specific number and name, DSPConfigurator
enters the next sequential unused preset number.
c. <Tab> to highlight the OK button and press the <Enter> key.
Alt
T
Enter
Figure 57. Saving a Preset Using Keyboard Navigation
DMP64 • Software Control 87
To Next Page
Loading...
