Extron electronics XTP II CrossPoint 1600 - Programming Guide

Programming
Guide
The XTP II CrossPoint Matrix Switcher can be remotely controlled via:
• The XTP System Configuration software (see the XTP System Configuration Software
help file, available at www.extron.com).
• Built-in HMTL pages (see HTML Operation, beginning on page 119)
• SIS commands (see below)
This section describes the operation of the XTP II CrossPoint Matrix Switchers via SIS
commands, including:
• Local Host-Control Ports
• Ethernet (LAN) Port
• Host-to-Switcher Instructions
• Switcher-Initiated Messages
• Switcher Error Responses
• Using the Command and Response Tables
• SIS Command and Response Table for Basic Matrix Switcher Commands
• SIS Command and Response Table for Input-Board-Specific Commands
• SIS Command and Response Table for Input-Endpoint-Specific Commands
• SIS Command and Response Table for Output-Board-Specific Commands
• SIS Command and Response Table for Output-Endpoint-Specific Commands
• SIS Command and Response Table for Advanced Matrix Switcher
Commands
• SIS Command and Response Table for IP- and Remote Port-Specific
Commands
• Special Characters
XTP II CrossPoint 1600, 3200, and 6400 Switchers • Programming Guide 76