kBox4 manual v9.5
exxentric.com/support 10
Flywheel Protection
Foot Block
The flywheel protection has to be assembled after
unpacking the kBox4.
This is highly recommended in order to protect against injury. First
remove the plastic film, then bend and hook the cover under the
bottom of the kBox4 and then in the holes in the front of the chassis.
See pictures below.
The foot block can be positioned straight or with an
angle and is secured by sliding the pins into the holes
in the front and the back of the kBox4 chassis.
Use the side with the lower angle for lateral movement and the
other side if you just want to maintain foot placement during
vertical work.
To Next Page
Loading...
