F'real FRLB4 - Blender Maintenance; Daily Blender Cleaning and Inspection; Weekly Blender Seal and Sensor Cleaning

4
1
Open the front door and perform a visual inspecon to
verify the surfaces are clean.
Wipe down the blender daily with a so cloth and soluon
or glass cleaner.
3
Wipe down the Cup Holder and underneath the Cup Holder
in the Drip Pan area with a damp cloth.
Drip Pan
Do not spray soluon
directly onto the screens.
Press upwards on the Flip-Up Door to clean o any product
build-up around the blending chamber rim and gasket.
Be careful not to
damage the gasket.
Panels
Screens
4
2
Daily Blender Maintenance
1 2
Weekly Blender Maintenance
Locate the (3) cup sensors underneath the front door.
Use a damp coon swab and wipe them down.
1 2
Open front door and locate the seal around the chamber
opening and follow the steps below:
1. Remove the seal
2. Clean seal with a damp cloth and rinse
3. Clean chamber opening rim, inside and out
4. Re-install the seal
5. Wipe down the door
3 4
Cup Holder
5