Need help?Do you have a question about the F'real FRLB4 and is the answer not in the manual?
Steps for daily cleaning and inspection of the blender's exterior surfaces and components.
Procedure for cleaning the blender's chamber seal and cup sensors weekly.
Commands for accessing system settings, diagnostics, and user interfaces.
Commands for controlling rinse cycles, steam, and cup holder operation.
Troubleshooting for Mix Motor and Position Motor peak current limit exceeded errors.
Troubleshooting for pump motor peak current limit exceeded errors.
Troubleshooting for blending time-out errors.
Troubleshooting for flip-up door misalignment and carriage switch errors.
Troubleshooting for home sensor malfunctions and steamer thermistor issues.
Troubleshooting for chamber and scour thermistor short or open circuit errors.
Troubleshooting for homing time-out errors.
Troubleshooting for sanitize sequence time-out errors.
Troubleshooting for steamer temperature outside allowable range errors.
Troubleshooting for scour temperature range and rinse water-shot time errors.
Troubleshooting for lower scour minimum and maximum flow limit errors.
Troubleshooting for upper and lower scour maximum flow limit errors.
Troubleshooting for upper scour maximum flow limit errors.
Troubleshooting for rotary flow limits and heater temperature control errors.
Troubleshooting for flip-up door open errors and mix motor circuit issues.
Troubleshooting for position and pump motor open circuit detected errors.
Troubleshooting for accumulator purge volume too high errors.
Troubleshooting for chamber thermistor range and sanitize cycle errors.
Troubleshooting for DC power bus errors and motor FET failures.
Troubleshooting for scour tank recharge and steamer thermal shock errors.
Troubleshooting for water shot duration and parameter check errors.
Troubleshooting for 'remove cup lid' and 'close front door' consumer errors.
Troubleshooting for 'something in the way of the cup holder' consumer error.
Troubleshooting for product temperature and motor cool down consumer errors.
Troubleshooting for 'needs water' and unexpected error code C11 consumer errors.
Troubleshooting SBC boot-up failures and operating system selection issues.
Troubleshooting for the screen freezing on 'Checking Hard Disk' during boot-up.
Troubleshooting for black screens, no signal, or static screens after blender boot-up.
Troubleshooting for registration requirements and touchscreen calibration problems.
Troubleshooting for front door operation problems and water leaks.
Troubleshooting for grinding noises during the mixing process.
Troubleshooting for shakes that are too thin or too thick in consistency.
General| Brand | F'real |
|---|---|
| Model | FRLB4 |
| Category | Beverage Dispenser |
| Language | English |
To Next Page