13
ENGLISH
2A PREPARING THE LEAVES
Prepare the leaves as described below.
1. Secure to the leaf, the leaf fitting profile cut to the same
length, and secure it with adequate screws on the upper
part (fig. 17).
2. Place two carriages on each leaf making use of the supplied
plates and screws; then mount the leaf and carriage unit on
the sliding profile, as shown in fig. 18 .
3. Secure the carriages on the leaf, using the dimensions in
figure 9 for the double leaf, and fig. 7-8 for the single leaf.
Tighten the carriage securing screws.
4. Cut the lower guide profile to the same length as the leaf
and secure with adequate screws on the lower part.
5. If specified, insert the brush in the seat of the sliding profile
Fig. 19 ref. .
Use an Allen key M5.
Use an Allen key M5.
To lock the 2 Allen screws of the side and central mechanical
stops, use an Allen key M5( fig.15 and fig.16 ).
fig. 18
fig. 17
fig. 19
fig. 15
fig. 16
fig. 14
Important : place the side and central mechanical stops
correctly, abutting with the profile, before
blocking them (fig.14
).
To Next Page
Loading...
