25
ENGLISH
13A INSTALLING THE CLOSING HOUSING
• Lay the closing housing on the spacers you had previously
mounted, as shown in Fig. 43 or .
• To keep the housing open, lift it (Fig. 43 ref. ) and push it
(Fig.43 ref. ) toward the profile until the metal protrusion fits
in the profile seat.
• Secure the parachute cables in the appropriate seats (Fig. 43
ref. )
•
The closing housing is locked in line with the two side panels
The closing housing is locked in line with the two side panels
and the central plate or the fixing brackets
and the central plate or the fixing brackets (Fig. 43 ref. )
• The closing housing is pre-marked to adapt it to different leaf
thickness values. Eliminate excess profile by cutting at the
points indicated in fig. 43 ref. .
If you are using the internal release, in order to close
the housing correctly, drill a hole near the release
knob.
fig. 43
We recommend you to use the central plate only
We recommend you to use the central plate only
with VP (passage width ) from 1500mm or higher.
with VP (passage width ) from 1500mm or higher.
To Next Page
Loading...
