FAAC E024U - Battery Charger and Firmware Upgrade; Disabling the Battery Charger; Firmware Upgrade Procedure

SETTING
+
DL 1
DL 2
DL 3
DL 4
DL 5
J24
SETTING
+
DL 1
DL 2
DL 3
DL 4
DL 5
J24
To disable the battery charger unplug jumper J24
J24 PRESENT = BATTERY CHARGING ACTIVE
J24 NOT PRESENT = BATTERY CHARGING NOT ACTIVE
9.1 DISABLE THE BATTERY CHARGER
SETTING
+
DL 1
DL 2
DL 3
DL 4
DL 5
J24
1. Disconnect the batteries if they are present.
2. Turn the AC power off and insert the Flash Drive into the
USB A input on the board
3. Turn the AC power back on. The USB2 LED will start to ash
to conrm the beginning of the software update. (WAR-
NING: DON’T TURN THE POWER OFF OR REMOVE
THE FLASH DRIVE UNTIL THE USB2 LED TURNS OFF.
4. Wait until the USB 2 LED turns off
5. Remove the USB Flash drive.
6. Cycle power, reconnect the batteries if needed and execute
a new SETUP procedure (See chapter 6)
For the upgrade you need a USB Flash Drive, where you have
to copy the le supplied by FAAC. Then follow these steps:
WARNING: Only upgrade the rmware with the proper le
supplied by FAAC. otherwise the board could be damaged
The E024U board keeps the operating rmware in a eld pro-
grammable memory, it can be easily upgraded through the on
board USB port
10. FIRMWARE UPGRADE
A15
E024U CONTROL BOARD