Need help?Do you have a question about the FAAC KP CONTROLLER and is the answer not in the manual?
General| Brand | FAAC |
|---|---|
| Model | KP CONTROLLER |
| Category | Controller |
| Language | English |
Explains how to maintain settings on the 950 MPS board via the ADVANCED MENU for complete programming.
Describes the lock function to inhibit operation using a key combination or an internal jumper.
Refers to the exploded view for installation details, noting openings for cable routing.
Details the connection to the 950 I/O board using a 2x0.5mm² cable up to 50m.
Describes the diagnostic function that signals faults via flashing LEDs, referring to a table for fault codes.
Lists fault numbers, their meanings, and corresponding LED status combinations for diagnosis.
Initiates door initialization and parameter self-learning.
Restores normal operating conditions following faults.
Inhibits KP-CONTROLLER operation using a key combination.
Presents the main programming menu structure for accessing various settings.
Defines how the system reacts to repeated obstacle detection during operation.
Enables or disables the electric lock based on installation status.
Manages two doors for synchronized opening/closing based on interlock settings.
Shows system cycle count and details current faults, referencing fault codes.
Initiates the reset procedure to restore normal operation after fault elimination.
Provides access to hardware info, cycle counts, fault numbers, and system reset.
Performs a functional test of the automated system and signals faults.
To Next Page
