FAAC Estate Swing E-SL 1800 - Component Description; Description of Terminal Block J13; Technical Specifications

3
3 TECHNICAL SPECIFICATIONS
Power supply
120 V~ 50 Hz
Power consumption
from mains stand-by
10 W
Motor max. load
6 A
Accessory
power supply
24 Vdc
Accessory
max. current
24 Vdc max. 500 mA
BUS-2EASY max. 500 mA
Environmental
temperature
(-20 - +55) °C
Flasher load
24 Vdc - 15 W
Output load
24 Vdc - 100 mA (1)
Pr otection
fuses
F1 = T1A - 250V
F unction
logics
Semiautomatic, Semiautomatic “step“,
Automatic, Automatic “step”, Auto-
matic with timer function, Automatic
Safety devices, Automatic Safety devices
“step“, Automatic with reverse on pause,
Semiautomatic “b”, Mixed logic “ b C ”,
Dead-man .
Work time
P rogrammable (from 0 to 10 min .)
P ause time
OPEN A / OPEN B
P rogrammable (from 0 to 10 min .)
Motor power
Adjustable over 50 levels
Opening-closing
motor speed
Adjustable over 10 levels
Connector Inputs/
Outputs
P ower supply, Battery, Motor, Module
XF433/868, Motor lock electric release bat -
teries, Motor L ock , USB
Inputs/Outputs in
terminal block
BUS -2EA SY , OPEN A, OPEN B/CL OSE/SAFE ,
ST OP/SAFE , GND, Opening and closing
photocells, +24 V, Mains power supply ,
Flasher, Electric release motor lock, OUT
Programmi ng
1
st
and 2
nd
level with 3 keys (+, -, F) and
display .
2.2 DESCRIPTION OF TERMINAL BLOCK J13
INPUT
No
DESCRIPTION
1
OPEN A
Device with N.O. contact
that causes total opening
of the gate
2-6
GND
Accessory power
supply negative
3
OPEN B / CLOSE /
SAFE
Device with N.O. contact
that causes partial opening
of the gate or reclosing of
the gate according to the
selected function logic
4
STOP / SAFE
Device with N.C. contact
that halts the gate
5
FSW OP
Device with N.C contact
that reverses the motion
during gate opening
7
FSW CL
Device with N.C contact
that reverses the motion
during gate closing
8
+24 V
Accessory power supply
positive
ENGLISH
2.1 COMPONENT DESCRIPTION
LCD SIGNALLING AND PROGRAMMING DISPLA Y
SW1 PROGRAMMING PUSH-BUTT ON " F ".
SW2 PROGRAMMING PUSH-BUTT ON " - ".
SW3 PROGRAMMING PUSH-BUTT ON " + ".
SW4 “ SETUP ” PUSH-BUTT ON
L eds INPUTS ST A TUS CONTROL LED
J1 MAIN POWER SUPPLY CONNECTOR
J2 TRANSFORMER PRIMARY WINDING CONNECTOR
J3 TRANSFORMER SECONDARY WINDING CONNECTOR
J4 EMERGENCY BATTERY CONNECTOR (ACCESSORY)
J5 MO T OR CONNECTOR
J6 FLASHER OUTPUT CONNECTOR
J9
MO T OR L OCK AND MO T OR RELEA SE
CONTACT CONNECTOR
J10 OUT OUTPUT CONNECTOR
J11 USB CONNECTOR FOR PC CONNECTION
J12 BUS-2EASY DEVICE CONNECTION CONNECTOR
J13 INPUT CONNECTOR IN CONNECTOR BL OCK
J14 RADIO RECEIVER MODULE CONNECTOR FOR OMNIDEC
LCD1 SIGNALLING AND PROGRAMMING DISPLA Y
F1 PROTECTION FUSE
(1) The output load must be considered
as already included in the max. current
available for the accessories