FAAC B680 User Manual

B680 Top & Bottom Skirt
Assembly Instructions
1. Push plastic inserts into 8mm holes on both sides of the beam.
2. Use M6 Hex bolts to secure vertical strips to the beam. Use 1 x plastic washer
under the bolt head and 3 x plastic washers between the vertical strip and the
beam to act as a spacer.
3. Repeat with another strip on the other side of the beam, ensure that both
vertical strips are orientated with their tips bending away from each other.
Unit 6, Hamilton Close, Houndmills Estate, Basingstoke, Hampshire, RG21 6YT
Tel: 01256 318100 Fax: 01256 318101 Tech helpline: 01256 318111 W: www.faac.co.uk

FAAC B680 Specifications

General

Temperature Range	-20°C to +55°C
Protection Class	IP54
Motor Type	Brushless
Opening Speed	Adjustable
Control Voltage	24 V DC
Power Supply	230 V AC (+6% -10%) 50 Hz
Max Boom Length	8.3 m
Usage Type	Residential
Max Gate Weight	Not applicable
Max Gate Length	Not applicable
Maximum Leaf Width	Not applicable

Summary

B680 Top & Bottom Skirt Assembly

Step 1: Insert Plastic Inserts

Insert plastic inserts into 8mm holes on both sides of the beam for skirt assembly.

Step 2: Secure Vertical Strips

Use M6 Hex bolts and washers to secure vertical strips to the beam, using washers as spacers.

Step 3: Orientate Vertical Strips

Attach the second vertical strip, ensuring its tip bends away from the first strip.

Step 4: Attach Horizontal Strip

Bolt vertical strips to the horizontal strip using M5 bolts and washers at top and bottom.

Step 5: Fit Anchor Bracket

Secure the anchor bracket to the barrier frame using countersunk screws in the outer holes.

Step 6: Secure Barrier Cover

Shorten the in-fill strip and bolt the cover and case to the barrier structure.

Step 7: Connect Link Arm

Connect the link arm from the bottom of the skirt to the anchor bracket.

B680 Skirt Dimensions and Balancing

Dimensional Overview

Diagram illustrating the key dimensions of the B680 Top & Bottom Skirt.

Skirt Balancing Table

Table for selecting the correct rocker arm hole based on beam length and accessories.