B680 Top & Bottom Skirt
Assembly
Instructions
4. Using the M5 bolts and nylon washers, bolt through the end of the fi rst vertical
strip, then horizontal strip and then the second vertical strip. Repeat at the top
and bottom of each vertical strip.
Note: The top and bottom strips will need to be joined in the centre and
trimmed with a hacksaw to the length required if too long.
5. Fit anchor bracket to barrier frame. This can be done before the cover is fi tted
or afterwards. Secure the bracket using countersunk screws in the two outer
holes.
Unit 10, The Hatch Ind Park, Basingstoke, Hampshire, RG24 7NG
Tel: 01256 318100 Fax: 01256 318101 Tech helpline: 01256 318111 W: www.faac.co.uk
To Next Page
Loading...
