B680 Top & Bottom Skirt
Assembly
Instructions
6. To secure the barrier cover the in-fi ll strip needs to be shortened by cutting
approximately 25mm from the lower edge. The cover and case are then
secured by bolting through the in-fi ll strip and the centre hole in the bracket
and into the threaded hole in the barrier structure.
Note: the barrier should be tested and the spring balanced prior to fi tting the
cover as this makes spring adjustment easier.
7. Fit the link arm to connect from the bottom of the skirt to the anchor bracket.
8. The fi nished skirt (pictures below are from the unpainted pre-production unit)
Unit 10, The Hatch Ind Park, Basingstoke, Hampshire, RG24 7NG
Tel: 01256 318100 Fax: 01256 318101 Tech helpline: 01256 318111 W: www.faac.co.uk
To Next Page
Loading...
