1 DESCRIPTION
These instructions apply to the following models:
S800H SB - S800H CBAC / 100° - 180°.
FAAC S800H is an automated system in a hydraulic enbloc (CLASS III), permitting vehicle access through swing
leaf gates which, when installed invisibly in the ground, does not alter the appearance of the gate. The mo-
del with a hydraulic shut-down facility does not require installation of an electrical lock, as it guarantees mechanical
shut-down of the leaf up to 2 m when the motor is not operating. The model without a hydraulic shut-down facility always requires
one or more electrical locks to ensure the leaf is mechanically shut down.
Fig.1
a Bleed screw
b Support handle
c Pinion
d Securing screws
e Screw for adjusting travel-limit
mechanical stops
f Hydraulic release
g Oil filling plug
h Motor
i Electronic encoder
j Bearing case
k Holes for securing the cover
l Slots for securing the jack
m Bearing bush
n Gate support bracket
o Key-operated release device
p Wings for walling the
bearing case.
q Hole for power cable or
drain pipe
r Release and
adjustment key and
supporting bush
s Closing cover
t Grooved bush
2 TECHNICAL SPECIFICATIONS
Fig.2
a S800H Operators with encoder
2x0.5 mm ² / AVG 20 for encoder bus
(Max. length 100 m)
b Bus 2 Easy Photocells 2x0.5 mm ² / AVG 20
(Max. length 100 m)
c Control unit
(To be selected according to the installed power supply)
2x2.5 mm ² / AVG 12 for powering
d Key operated push-button 2x0.5 mm ² / AVG 20
e Flashing lamp 24 V 2x1.5 mm ² / AVG 16
3 ELECTRICAL PREPARATIONS
CBAC
SB
24
60 (*)
IP 67
FAAC HP OIL
-20° C +55°C
Continous duty at 55°C
Supplied Not supplied
**
500 (E024S7) ; 600 (E124)
5.5 (E024S) ; 8.2 (E124)
113° (S800H 100°)
187° (S800H 180°)
2 4
800
To Next Page
Loading...
