TM2 X R MINI 26 A4518_6H82_Rev.A
REMOTE CONTROL MEMORY CLEARING
FULL MEMORY CLEARING
It is possible to delete singly all the memorized remote controls. When the last
one is deleted the control unit initial condition is restored. The same applies to the
single channels of a multichannel remote control: just select the channel to cancel.
Tn: Remote control to be cleared
The full memory clearing can be performed in two ways:
1) WITH THE REMOTE CONTROL
Tn: Already programmed remote control
2) WITH THE SET BUTTON
approximately 8 sec
TnTn Tn (2 sec)
+
A B
B
A
TnTn Tn (4 sec)
+
A B
+
A B
B
EN
To Next Page
Loading...
