EasyManua.ls Logo

FAAC TM2 X R MINI - Wired Control with Button; Button Control Step-by-Step; Operation with Sun;Wind Sensor; Sun Appearance Automatic Operation

FAAC TM2 X R MINI
104 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TM2 X R MINI 30 A4518_6H82_Rev.A
OPERATION WITH SUN/WIND SENSOR
3 minutes after the sun comes out, the awning opens
completely.
10 minutes after the sun disappears, the awning closes
completely.
After 2 seconds, the awning closes completely. It is not
possible to open it until 8 minutes have passed with the wind
under the threshold speed. The red Led  ashes.
It is possible to associate a wind or sun/wind sensor with the control unit. In corre-
spondence to climatic events, the appearance or disappearance of the sun and/or
with a wind alarm, the control unit performs the following operations:
Event Automatic movement
Appearance of the
sun (sunlight over
threshold level)
Disappearance of the
sun (sunlight under
threshold level)
Wind alarm (wind
over the threshold
speed)
WIRED CONTROL WITH BUTTON
In this setup it is not possible to use the DM mode.
Set the control unit to the latching mode (MC) and connect the button between
Phase and the input of the optional wired switch (white wire).
Each time the button is pressed the control unit works in step-by-step mode: up-
stop-down-stop.
Phase-220Vac
Neutral-220Vac
MOTOR
COM
UP
DOWN
WHITE
RED
YELLOW
BROWN
BLUE
GREEN
6
5
4
3
2
1
PINK
ANT
P1
LED PROG
PROG
Remote and wired control of the motor with step-by-step button
EN

Table of Contents

Related product manuals