FAAC XKP W Series - Delete All User Codes; Change Password; Restore Factory Settings; Direct Radio Channel Button E

XKP W 6 532110 - Rev.A
3.3 DELETE ALL USER CODES
When the XKP W is waiting for an operation, enter:
3 # 3 #
 60 s
3.4 CHANGE THE PWD
Enter the PWD (maximum of 6 digits). Only numeric codes can be entered, in any combination from
0 to 999999 e.g. 240764.
When the XKP W is waiting for an operation, enter:
4 # new PWD # new PWD #
 60 s
3.5 RESTORE FACTORY SETTINGS
This restores the XKP W to its factory settings: user code memory empty, direct radio channel (button
E) disabled , Easy Operation, PWD: 1 2 3 4, randomised radio codes . When finished, the XKP W
exits from programming mode and goes into standby.
When the XKP W is waiting for an operation, enter:
5 # 5 #
  
3.6 DIRECT RADIO CHANNEL BUTTON E
Button E can be used to activate a radio channel without having to enter a user code (direct radio
channel).
By default, the direct radio channel button E is disabled. To enable it, specify the radio channel (Ch.
no. from 1 to 4) to be activated. To disable it, press 0 instead of the number of the radio channel.
When the XKP W is waiting for an operation, enter:
6 # Ch # (enabled on the radio channel entered)
or
6 # 0 # (disabled)  60 s
E.g.: Button E, enabled for direct radio channel 1: 6 # 1 #