XKP W 10 532110 - Rev.A
A B
Ch4
Ch2 Ch3Ch1
LED
verde/rosso
green/red
rouge/vert
rot/grün
rojo/verde
rood/groen
Teaching XKP WLearning XKP W
Learning XKP WTeaching radio control
3.9 LEARN THE RADIO CODE
Learn the radio code. This procedure allows the
radio code of a channel to be ‘learnt’ from a SLH
master radio transmitter. This procedure must
be carried out for each radio channel that you
wish to use.
Both Master XKP W and Slave XKP W units can
learn the code. The teaching device must be a
SLH master radio transmitter.
When the XKP W is waiting for an operation, enter:
9 # Ch. #
25 s
E.g. for the radio code on radio channel Ch 1: 9 # 1 #
Bring the two devices into contact with one another as shown in the figure (A or B) within 25 s and
transmit the radio code from the radio control or from the teaching XKP W:
- on the radio control press buttons P1 and P2 simultaneously, then release them and press the
channel number
- on the teaching XKP W follow the entire procedure indicated in § 3.8
The XKP W learns the radio code on the channel entered, signals OK and waits for an
operation. 60 s
Repeat the procedure for each radio channel required. When using the XKP W for the first time, each
radio channel has to be activated twice in succession:
Easy Operation enter:
user code E wait until the Green LED turns off, then press E
Advanced Operation enter:
# user code E Ch. wait until the green LED turns off, then repeat Ch.
To Next Page
Loading...