XKP W 4 532110 - Rev.A
Standby
# PWD # 1…12 # (§ 3.1… § 3. 12)
3. PROGRAMMING
The programming function is PWD protected. In order to restrict access, set a new PWD when the
system is programmed for the first time. Do not give the PWD to other people.
Factory-set PWD: 1 2 3 4
When the XKP W is waiting for an operation, enter:
# PWD #
60 s
Choose the option 1 ... 12 from the menu and carry out the procedure following the
instructions in the relative paragraph.
E.g. for a new user code, enter:
1 # 60 s
If the XKP W indicates an error, it should be reprogrammed correctly.
After the OK message appears, the XKP W waits for an operation for 60 s.
When the XKP W is waiting for an operation, it is possible to carry out another operation from the menu.
Press E to end the programming (the programming also ends if the timeout expires without any
keys being pressed).
When programming has been completed, the XKP W reverts to standby mode.
1 Store a user code (§ 3.1 )
2 Delete a user code (§ 3.2)
3 Delete all user codes (§ 3.3)
4 Change the PWD (§ 3.4)
5 Restore factory settings (§ 3.5)
6 Direct radio channel button E (§ 3.6)
7 not used
8 Teach the radio code (§ 3.8)
9 Learn the radio code (§ 3.9)
10 Set the XKP W SLAVE (§ 3.10)
11 Randomise the radio codes (§ 3.11)
12 Easy or Advanced Operation (§ 3.12)
E/end of wait for operation button
To Next Page
Loading...