FAAC XKP W Series - Teach Another XKP W Unit

XKP W 8 532110 - Rev.A
TEACH ANOTHER XKP W
When the XKP W is waiting for an operation, enter:
8 # Ch
 25 s
E.g. transmit the Ch 1 radio code: 8 # 1
Place the target XKP W into learning mode on the required radio channel within 25 s (see § 3.9) and
bring the two devices into contact with one another as shown in the figure. Then press:
# (keep it pressed until confirmation is given that the code has been learnt, then release it)  60 s
The code of the radio channel entered is transmitted (Green LED on). Make sure that the target XKP W
confirms that it has been learnt: Green LED on for 0.5 s and 1 beep.
Repeat the procedure for each radio channel required. When using the new XKP W for the first time,
each radio channel has to be activated twice in succession.
Easy Operation enter:
user code E wait until the Green LED turns off, then press E
Advanced Operation enter:
# user code E Ch. wait until the green LED turns off, then repeat Ch.
Teaching XKP W
Learning XKP W