48
OPERATION
Control Panel
• Immediately after the appliance is connected to electrical mains, all displays will light up
briey. Your induction hob is then ready for use.
• The induction hob is equipped with electronic touch control sensor elds, which are oper-
ated by touching with a nger for at least 1 second.
• Touching of a sensor is accompanied by an acoustic signal to acknowledge.
No objects should be placed on the sensor elds (this could cause an error). Touch
sensor elds should be always kept clean.
Switch on the appliance
Touch and hold the on/o sensor for at least 1 second . Hob indicates correct operation
(active) when “0” is shown on the display .
If you do not set the desired heat setting of the cooking zone within 10 seconds of
activating the hob, the appliance will turn o automatically.
Activate cooking zone and set the heat setting.
• Turn on the hob with the sensor.
• Place the cookware on the desired cooking zone.
• The cookware will be automatically detected and the relevant display will show as-
hing "0."
When cookware is detected on more than one cooking zone touch the display
of the cooking zone you want to use. It will ash.
• To select the desired heat setting slide your nger across the sensor starting from
the left (the display will show the selected heat setting).
• The cooking zone operates.
A cooking zone is active when its display shows a digit or a letter. This indicates the
cooking zone is ready for the heat setting to be set or changed.
To Next Page
Loading...
