(when tting beneath a work top) In most modern tted kitchens there is only one
single work top under which cabinets and electrical appliances are tted. In this case remove
the work top of the dishwasher by unscrewing the screws under the rear edge of the top (a).
Attention
After removing the work top, the screws MUST BE screwed again under the rear edge
of the top (b). The height will then be reduced to 815 mm, as scheduled by the International
Regulations (ISO) and the dishwasher will t perfectly under the kitchen working top
Built-In Installation(for the integrated model)
Step 1. Selecting the best location for the dishwasher
The installation position of dishwasher should be near the existing inlet and drain hoses
and power cord. Illustrations of cabinet dimensions and installation position of the
dishwasher.
1. Less than 5 mm between the top of dishwasher and cabinet and the outer door
aligned to cabinet.
Electrical, drain
and water supply
line entrances
Space between cabinet
bottom and oor
for 60cm model
for 45cm model
2
To Next Page
Loading...
