Install the hook on the aesthetic wooden panel and put the hook into the slot of the
outer door of dishwasher (see gure A). After positioning of the panel , x the panel
onto the outer door by screws and bolts (See gure B).
1. Take away the four short screws
2. Pin up the four long screws
1. The door springs are set at the factory to the proper tension for the outer door. If aesthetic wooden
panel are installed, you will have to adjust the door spring tension. Rotate the adjusting screw to drive
the adjustor to strain or relax the steel cable.
2. Door spring tension is correct when the door remains horizontal in the fully opened position, yet rises
to a close with the slight lift of a nger.
To Next Page
Loading...
