Fagor 8065 - Page 23

Error solving manual.
CNC 8060
CNC 8065
·23·
(REF: 1709)
1060 'N label value out of range'
DETECTION During execution.
CAUSE Invalid block number "N".
SOLUTION The block number must be a positive value lower than 2147483646.
1061 'Nonexistent G function'
DETECTION During execution.
CAUSE The programmed G function does not exist.
SOLUTION Check the program.
1062 'Incompatible G functions'
DETECTION During execution.
CAUSE Two G functions incompatible with each other have been programmed in the block.
SOLUTION Program the functions in different blocks.
1063 'Incompatible G functions (G108/G109/G193)'
DETECTION During execution.
CAUSE Two or more G functions incompatible with each other have been programmed in the
block.
SOLUTION Program the functions in different blocks.
1064 'Incompatible G functions (G196/G197)'
DETECTION During execution.
CAUSE Two or more G functions incompatible with each other have been programmed in the
block.
SOLUTION Program the functions in different blocks.
1065 'Incompatible G functions (G17/G18/G19/G20)'
DETECTION During execution.
CAUSE Two or more G functions incompatible with each other have been programmed in the
block.
SOLUTION Program the functions in different blocks.
1066 'Incompatible G functions (G136/G137)'
DETECTION During execution.
CAUSE Two or more G functions incompatible with each other have been programmed in the
block.
SOLUTION Program the functions in different blocks.
1067 'Incompatible G functions (G40/G41/G42)'
DETECTION During execution.
CAUSE Two or more G functions incompatible with each other have been programmed in the
block.
SOLUTION Program the functions in different blocks.
1068 'Incompatible G functions (G151/G152)'
DETECTION During execution.
CAUSE Two or more G functions incompatible with each other have been programmed in the
block.
SOLUTION Program the functions in different blocks.
1069 'Incompatible G functions (G54-G59/G159)'
DETECTION During execution.
CAUSE Two or more G functions incompatible with each other have been programmed in the
block.
SOLUTION Program the functions in different blocks.
1070 'Incompatible G functions (G5/G7/G50/G60/G61)'
DETECTION During execution.
CAUSE Two or more G functions incompatible with each other have been programmed in the
block.
SOLUTION Program the functions in different blocks.