Error solving manual.
CNC 8060
CNC 8065
·32·
(REF: 1709)
1165 'Nonexistent variable'
DETECTION During execution.
CAUSE The possible causes are:
• The requested variable does not exist.
• Syntax error in the name of the variable.
• The variable is an array and the array index has not been indicated.
• A general variable has been requested for a particular axis or the other way
around.
SOLUTION Check the program.
1166 'Square root of a negative number'
DETECTION During execution.
CAUSE The mathematical expression contains a square root (SQRT) of a negative number.
SOLUTION Check the program.
1167 'Logarithm of a negative number or zero'
DETECTION During execution.
CAUSE The mathematical expression contains a logarithm (LOG/LN) of a negative number
or zero.
SOLUTION Check the program.
1168 'Variable index out of range'
DETECTION During execution.
CAUSE One of the indexes defined in the array variable is wrong.
SOLUTION The minimum admissible index for an array variable is 1 and the maximum depends
on which variable it is. There are particular instances where the index 0 is admitted:
G.GS, G.MS, G.LUP1 to G.LUP7, G.LUPACT and MTB.P.
1170 'The #SYNC POS instruction must be programmed alone in the block'
DETECTION During execution.
CAUSE The instruction has not been programmed alone in the block.
SOLUTION Check the program. The instructions must be programmed alone in the block, only
the block label may be added.
1171 '# instructions must be programmed alone in the block'
DETECTION During execution.
CAUSE The instruction has not been programmed alone in the block.
SOLUTION Check the program. The instructions must be programmed alone in the block, only
the block label may be added. The only exception is the #AXIS instruction that must
be programmed in the same block as function G201.
1172 'Instruction not allowed while tool radius compensation is active'
DETECTION During execution.
CAUSE The CNC has tried to execute an instruction that is incompatible with tool radius
compensation.
SOLUTION Cancel tool radius compensation to execute the instruction.
1173 'The #UNLINK instruction must be programmed alone in the block'
DETECTION During execution.
CAUSE The instruction has not been programmed alone in the block.
SOLUTION Check the program.
1174 '#LINK: a new coupling (slaving) cannot be defined if a previous one is active'
DETECTION During execution.
CAUSE The CNC has tried to activate a second axis coupling (slaving ) without deactivating
the first one.
SOLUTION Check the program. Cancel the first coupling (slaving) before activating the second
one. To have both couplings, cancel the first one and activate both with a single #LINK
instruction.
1175 '#LINK: no coupling (slaving) has been defined'
DETECTION During execution.
CAUSE No axis coupling (slaving) has been defined in the #LINK instruction.
SOLUTION Program the master and slave axes in the #LINK instruction.
To Next Page
Loading...
