Error solving manual.
CNC 8060
CNC 8065
·33·
(REF: 1709)
1176 '#LINK: the master axis does not belong to the current axis configuration'
DETECTION During execution.
CAUSE The possible causes are:
• The master axis of the coupling does not exist or is not available in the channel.
• The CNC has tried to deactivate a coupling whose master axis does not exist or
is not available in the channel.
SOLUTION The master and slave axes must exist in the channel that executes the instruction.
1177 '#LINK: the slave axis does not belong to the current axis configuration'
DETECTION During execution.
CAUSE The possible causes are:
• The slave axis of the coupling does not exist or is not available in the channel.
• The CNC has tried to deactivate a coupling whose slave axis does not exist or
is not available in the channel.
SOLUTION The master and slave axes must exist in the channel that executes the instruction.
1178 '#LINK: the slave axis cannot be an axis of the main plane'
DETECTION During execution.
CAUSE The slave axis of the coupling is one of the main three axes.
SOLUTION Check the program.
1179 '#LINK: The master and slave axes must be of the same type (AXISTYPE)'
DETECTION During execution.
CAUSE The master and slave axes of the coupling are not of the same type, linear or rotary.
SOLUTION Both axes of the coupling must be of the same type (parameter AXISTYPE).
1180 '#LINK: The master and slave axes must have the same mode (AXISMODE)'
DETECTION During execution.
CAUSE The master and slave axes of the coupling are rotary, but they are not of the same
type, linearlike or module.
SOLUTION Both axes of the coupling must be of the same type (parameter AXISMODE).
1181 '#LINK: An axis active in G201 cannot be defined as slave'
DETECTION During execution.
CAUSE The slave axis of the coupling is active in additive manual mode (G201).
SOLUTION Cancel the additive manual mode in order to be able to couple the axis.
1182 '#LINK: too many couplings programmed'
DETECTION During execution.
CAUSE Too many couplings have been defined.
SOLUTION The maximum number of couplings that may be active in a channel is equal to the
number of axes of the channel minus three.
1183 'The #LINK instruction must be programmed alone in the block'
DETECTION During execution.
CAUSE The instruction has not been programmed alone in the block.
SOLUTION Check the program.
1184 '#LINK: The master and slave axes are the same'
DETECTION During execution.
CAUSE The master and slave axes of the coupling are the same axis.
SOLUTION The master and slave axes must be different.
1185 '#LINK: An axis cannot be a slave of several masters'
DETECTION During execution.
CAUSE An axis is the slave of several masters.
SOLUTION An axis can only be the slave of one master.
1186 ''#LINK: A master axis cannot be a slave in another coupling and vice versa'
DETECTION During execution.
CAUSE An axis cannot be the slave in a coupling and the master in another.
SOLUTION An axis cannot be the master in a coupling and the slave in another.
To Next Page
Loading...
