Fagor 8065 - Page 34

Error solving manual.
CNC 8060
CNC 8065
·34·
(REF: 1709)
1187 '#AXIS: repeated axis name'
DETECTION During execution.
CAUSE The same axis has been programmed more than once in the instruction.
SOLUTION Check the program.
1188 '"["not expected'
DETECTION During execution.
CAUSE Syntax error in the instruction.
SOLUTION Check the program.
1189 '#MPG: too many parameters'
DETECTION During execution.
CAUSE The instruction has too many parameters.
SOLUTION The #MPG instruction admits a maximum of three parameters. Each one of them
represents the distance moved per handwheel pulse in each position of the switch.
1190 '#MPG: Negative or zero handwheel resolutions are not allowed'
DETECTION During execution.
CAUSE The #MPG instruction tries to define a negative or zero handwheel resolution.
SOLUTION The movement distance per handwheel pulse must be positive and other than zero.
1191 '#INCJOG: Negative or zero incremental jog distances are not allowed'
DETECTION During execution.
CAUSE The #INCJOG instruction tries to define a negative or zero distance.
SOLUTION The value of the incremental movement of the axis in each position of the switch must
be a positive value and other than zero.
1192 '#INCJOG: Negative or zero incremental jog feedrates are not allowed'
DETECTION During execution.
CAUSE The #INCJOG instruction tries to define a negative or zero feedrate.
SOLUTION The feedrate of the axis in each position of the switch must be a positive value and
other than zero.
1193 '#CONTJOG/#INCJOG: programmed feedrate out of range'
DETECTION During execution.
CAUSE The programmed feedrate is too high.
SOLUTION Check the program.
1194 '#INCJOG: too many parameters'
DETECTION During execution.
CAUSE The instruction has too many parameters.
SOLUTION The #INCJOG instruction admits a maximum of five groups of parameters. Each of
them represents the axis feedrate and movement for each position of the switch in
incremental jog.
1195 '#CONTJOG: too many parameters'
DETECTION During execution.
CAUSE The instruction has too many parameters.
SOLUTION The #CONTJOG instruction only admits one parameter that represents the axis
feedrate when the switch is in continuous jog.
1196 '#CONTJOG: Negative or zero continuous jog feedrates are not allowed'
DETECTION During execution.
CAUSE The #CONTJOG instruction tries to define a negative or zero feedrate.
SOLUTION The value of the axis feedrate must be a positive value and other than zero.
1197 '#SET OFFSET: positive lower offset'
DETECTION During execution.
CAUSE The lower axis travel limit for jogging has a positive value.
SOLUTION The lower axis travel limit for jogging must be negative or zero.