Fagor 8065 - Page 40

Error solving manual.
CNC 8060
CNC 8065
·40·
(REF: 1709)
1266 'The TLC feature is deactivated using the instruction #TLC OFF'
DETECTION During execution.
CAUSE The CNC has tried to modify the TLC function while it was active.
SOLUTION The CNC does not allow modifying the TLC function while it is active. To modify the
TLC function, first deactivate it and then activated again.
1267 'The RTCP functionality is canceled with the instruction #RTCP OFF'
DETECTION During execution.
CAUSE While RTCP is active, a #RTCP instruction other than #RTCP OFF has been
programmed.
SOLUTION To cancel the RTCP function, program #RTCP OFF. To change the values of the
RTCP, it must be canceled first.
1268 '#CS ON/#ACS ON: syntax error'
DETECTION During execution.
CAUSE The syntax of the instruction is wrong.
SOLUTION Check the program.
1269 '#CS ON/#ACS ON: the programmed angle is not valid'
DETECTION During execution.
CAUSE The programmed angle is wrong.
SOLUTION Program an angle within ±360º.
1270 'The coordinate transformation cannot be calculated'
DETECTION During execution.
CAUSE The CNC has not been able to solve a transformation from part-coordinates to
machine coordinates or vice versa.
SOLUTION Cancel the transformation, change the position of the axes and activate the
transformation again.
1271 'The axes of the active kinematics can neither be excluded nor modified'
DETECTION During execution.
CAUSE The CNC has tried to modify the configuration of the axes of a kinematics while it was
active.
SOLUTION Cancel the kinematics before modifying the configuration of the axes of the channel.
1272 'The axes of the active transformation can neither be excluded nor modified'
DETECTION During execution.
CAUSE The CNC has tried to modify the configuration of the axes of an inclined plane while
it was active.
SOLUTION Cancel the inclined plane transformation to modify the configuration of the axes of
the channel.
1275 'Position calculated by the inverted kinematics transformation out of range'
DETECTION During execution.
CAUSE The CNC has tried to do an unsolved transformation from machine coordinates to
part coordinates.
SOLUTION Cancel the transformation, change the position to be accessed and activate the
transformation again. Check the transformation if it is a user transformation.
1277 'The resulting zero offset exceeds the data range'
DETECTION During execution.
CAUSE The zero offset calculated from the coordinates programmed in function G92 is too
large.
SOLUTION Check the program.
1278 'G131/G133: wrong value'
DETECTION During execution.
CAUSE In function G131 or G133, the programmed percentage of acceleration or jerk is not
valid.
SOLUTION Program a percentage of acceleration or jerk that is positive and less than or equal
to 100.