Error solving manual.
CNC 8060
CNC 8065
·42·
(REF: 1709)
1292 'M function programmed twice'
DETECTION During execution.
CAUSE The same M function has been programmed more than once in the block.
SOLUTION Program both functions in different blocks.
1293 'H function programmed twice'
DETECTION During execution.
CAUSE The same H function has been programmed more than once in the block.
SOLUTION Program both functions in different blocks.
1301 'The tool length transformation exceeds the valid numeric format'
DETECTION During execution.
CAUSE The tool length transformation exceeds the valid numeric format.
SOLUTION Modify the values of the length transformation or those of the tool.
1302 'Wrong character in the name'
DETECTION During execution.
CAUSE Wrong character in the name of a label, subroutine or variable.
SOLUTION Check the program.
1303 'Variable name too long'
DETECTION During execution.
CAUSE Too many characters for the name of the variable.
SOLUTION The maximum number of characters allowed is 13.
1304 'Wrong spindle speed'
DETECTION During execution.
CAUSE The programmed speed is too low.
SOLUTION Check the program.
1305 'Programming not allowed while #MCS is active'
DETECTION During execution.
CAUSE The CNC does not allow executing the programmed function if the MCS function is
active. Some incompatible functions are:
• Zero offsets (G54-G59, G159, G92, G158, G53) on/off
• Measuring offset (G101, G102) on/off.
• Fixtures on/off ("V.G.FIX" variable).
• Mirror (G11/G12/G13/G14) image on/off.
• Programming in radius/diameters (G151/G152).
• Activate incremental programming (G91).
• Programming in mm/inches (G70/G71).
• Scaling factor (G72).
• Movement in G0, G1, G2, G3, G8 or G9 in Polar coordinates.
• Threading G63 or G33 in Polar coordinates.
• Polar origin (G30).
• Pattern rotation (G73).
• Instructions #FACE, #CYL and #RTCP.
SOLUTION Check the program.
1306 'The kinematics cannot be changed while tool radius compensation is active'
DETECTION During execution.
CAUSE The CNC has tried to change the kinematics while tool radius compensation was
active.
SOLUTION Cancel the compensation to define the new work plane.
1308 'An axis of the active transformation cannot be a slave'
DETECTION During execution.
CAUSE The slave axis of the coupling is part of the active kinematics.
SOLUTION Cancel the kinematics to be able to couple the axis. The axis involved in the active
kinematics can be master of a coupling.
To Next Page
Loading...
