Error solving manual.
CNC 8060
CNC 8065
·50·
(REF: 1709)
1395 'Function G74 with associated subroutine must be programmed alone in the block'
DETECTION During execution.
CAUSE If function G74 has an associated subroutine, it must be programmed alone in the
block or together with the block label.
SOLUTION Check the program.
1396 'Programming not allowed in MDI'
DETECTION During execution.
CAUSE That command cannot be executed in MDI.
SOLUTION Execute that command within the program.
1397 'The position programmed for the Hirth axis is wrong'
DETECTION During execution.
CAUSE The coordinate programmed for the Hirth axis does not correspond to a whole step.
SOLUTION The hirth axis only admits multiples of its pitch.
1398 'An axis with parameter HIRTH = NO cannot be activated as Hirth axis'
DETECTION During execution.
CAUSE The CNC has tried to activate (G171) or deactivate (G170) as a hirth axis one that
is not (parameter HIRTH).
SOLUTION Check the program. 'The axis cannot be activated as a hirth axis.
1399 'The axis cannot be activated as Hirth'
DETECTION During execution.
CAUSE The possible causes are:
• The hirth axis is one of the axes of the plane and tool radius compensation and/or
collision detection is active.
• The hirth axis is part of the active coordinate transformation.
• The hirth axis is part of the active kinematics and also an #RTCP, #TLC or #TOOL
ORI instruction is active.
SOLUTION Check the program.
1400 'Tool length change is not possible while RTCP is active'
DETECTION During execution.
CAUSE The CNC has tried to make a tool change while function RTCP was active.
SOLUTION Cancel the RTCP function to make the tool change.
1401 '#TLC ON not admitted without unselecting first'
DETECTION During execution.
CAUSE The CNC has tried to activate the TLC function and it is already active.
SOLUTION Check the program.
1402 '#LINK: The master and slave axes must have their HIRTH and HPITCH parameters set
the same way.
DETECTION During execution.
CAUSE The CNC has tried to couple two hirth axes, but one of them is not hirth or they both
have different pitches.
SOLUTION In order to include a hirth axis in a coupling, both axes must be hirth (parameter
HIRTH) and have the same pitch.
1403 '#LINK: a coupling cannot be defined if a Hirth axis is deactivated'
DETECTION During execution.
CAUSE The CNC has tried to couple two hirth axes, but one of them is deactivated.
SOLUTION In order to couple two hirth axes, both of them must be active (G171).
1404 'The gear associated with the programmed M function does not exist'
DETECTION During execution.
CAUSE The CNC has tried to make a spindle gear change using an M41 through M44
function, but the gear does not exist.
SOLUTION The number of gears available at the spindle is determined in the machine parameters
(parameter NPARSETS). The CNC will accept the M41 through M44 functions of the
existing spindle gears.
To Next Page
Loading...
