Fagor 8065 - Page 51

Error solving manual.
CNC 8060
CNC 8065
·51·
(REF: 1709)
1405 'The S value exceeds the maximum gear'
DETECTION During execution.
CAUSE The spindle has an automatic gear changer (parameter AUTOGEAR) and a speed
has been programmed that is higher than any of the existing gears for that spindle.
SOLUTION Program a lower spindle speed that may be reached with one of the gears existing
for that spindle. Check that the maximum speed defined in each gear is correct.
1406 '#CALL: does not admit parameter programming'
DETECTION During execution.
CAUSE The #CALL instructiont does not allow to program parameters.
SOLUTION Check the program.
1407 'Error when reading pocket data'
DETECTION During execution.
CAUSE When executing a 2D or 3D pocket, the CNC could not decode some of the data. This
may happen when the pocket data has been edited manually and a numeric value
has been replaced with a variable, the bracket at the end of the instructions
#DATAP2D, #DATAP3D has been eliminated, etc.
SOLUTION Edit the pocket again with the cycle editor.
1408 'It cannot be programmed if the spindle is not controlled in position'
DETECTION During execution.
CAUSE The CNC cannot execute the programmed function or instruction if the spindle is not
controlled in position.
SOLUTION The spindle must have an encoder.
1409 'Nesting of T functions with subroutine, not allowed'
DETECTION During execution.
CAUSE The CNC has tried to execute a tool change and the subroutine associated with the
T function (parameter TOOLSUB) contains another tool change.
SOLUTION A T function cannot be programmed inside the subroutine associated with the tool
change
1411 '#CD: wrong number of blocks'
DETECTION During execution.
CAUSE The number of blocks programmed in the instruction is wrong.
SOLUTION The maximum number of blocks to analyze depends on the CNC model; 200 blocks
(CNC 6065) or 40 (CNC 8060).
1412 '#DGWZ: graphics display area defined wrong'
DETECTION During execution.
CAUSE The axis limits have been defined wrong in the instruction.
SOLUTION Both limits may be positive or negative, but the lower limits of an axis must always
be lower than its upper limits.
1413 'The spindle positioning speed cannot be zero'
DETECTION During execution.
CAUSE The programmed positioning speed for function M19 is zero.
SOLUTION Program a positioning speed greater than zero using the command "S.POS".
1414 '#PARK: this instruction only admits one axis'
DETECTION During execution.
CAUSE The #PARK instruction only allows parking one axis.
SOLUTION Program a #PARK block for each axis to be parked.
1417 'File path too long'
DETECTION During execution.
CAUSE The maximum number of characters allowed for the path of a program or subroutine
has been exceeded.
SOLUTION The path of a program or subroutine may have a maximum of 120 characters. Move
the program or subroutine to another directory to reduce the number of characters
of the path.