Error solving manual.
CNC 8060
CNC 8065
·52·
(REF: 1709)
1418 'It is not possible to park axes of the active kinematics or transformation'
DETECTION During execution.
CAUSE The CNC has tried to park an axis that is part the active kinematics or transforms #CS,
#ACS, #ANGAX, #TANGCTRL.
SOLUTION Check the program. To park that axis, cancel the active kinematics or transformation.
1419 'Slaved axes (Gantry or Tandem) cannot be parked.
DETECTION During execution.
CAUSE The CNC has tried to park an axis that is part of a gantry, tandem axis or of an active
coupling (#LINK).
SOLUTION Check the program. To park that axis, cancel the coupling. The axes belonging to a
gantry or tandem pair cannot be parked.
1420 'Open control blocks at the end of the program'
DETECTION During execution.
CAUSE Some $IF, $FOR, etc. does not have its corresponding closing instruction.
SOLUTION Check the program.
1421 'The axes of the active transformation can neither be slaves nor parked'
DETECTION During execution.
CAUSE One of the axes involved in the programmed coordinate transformation is parked, is
a slave of a gantry pair or is a slave of an active coupling.
SOLUTION Unpark, deactivate the active coupling or undo the gantry pair in order to use the axis
in the coordinate transformation.
1422 '#CS ON/#ACS ON: wrong programmed mode'
DETECTION During execution.
CAUSE The programmed MODE parameter is wrong.
SOLUTION The value of the MODE parameter must be between 1 and 6.
1423 '#CS ON/#ACS ON: the parameter of an aligned axis must be 0 or 1'
DETECTION During execution.
CAUSE The value programmed as method for aligning the plane is wrong.
SOLUTION Check the program.
1424 'G function not allowed while MCS is active'
DETECTION During execution.
CAUSE The programmed G function cannot be executed while #MCS is active.
SOLUTION Check the program.
1425 'Block skip is only admitted at the beginning of the line'
DETECTION During execution.
CAUSE The "/" character is only admitted at the beginning of the program line.
SOLUTION Check the program.
1426 'The pocket was resolved with a different tool radius'
DETECTION During execution.
CAUSE The CNC generated the pocket with a tool radius other than the current one.
SOLUTION Generate the pocket again.
1427 'Axis programmed wrong'
DETECTION During execution.
CAUSE Syntax error when programming the instruction or G function; some axis is repeated
in a movement, the home searching order for the axes is missing in the G74 function
or the order of the axes in the system is missing in the G20 function.
SOLUTION Check the program.
1428 'The movement in the main plane must be programmed before the G function of the cycle'
DETECTION During execution.
CAUSE The coordinates of the starting point of the cycle are defined after the G function that
defines the cycle. The cycle considers the coordinates of the starting point as its own
parameters.
SOLUTION Program the coordinates of the axes before the G function of the cycle.
To Next Page
Loading...
