Error solving manual.
CNC 8060
CNC 8065
·53·
(REF: 1709)
1429 'Too many subroutines in the same block'
DETECTION During execution.
CAUSE The maximum number of subroutines that may be executed in the same block has
been exceeded.
SOLUTION The maximum number of subroutines that may be executed in the same block is 5.
Program the subroutines in different blocks or use subroutine nesting as necessary.
1430 'Numeric format exceeded'
DETECTION During execution.
CAUSE The value assigned to a data, variable or parameter exceeds the established format.
SOLUTION Check the program.
1431 'Wrong spindle position in M19'
DETECTION During execution.
CAUSE The value programmed for the spindle position in M19 is too high.
SOLUTION Program a smaller value.
1432 'A slave axis of a Gantry or coupling cannot be programmed'
DETECTION During execution.
CAUSE In instruction contains the slave axis of an active coupling or of Gantry pair.
SOLUTION In order to operate with the axis in those instructions, deactivate the active coupling
(#UNLINK) or undo the Gantry pair (by machine parameter).
1433 'A parked axis cannot be part of the main plane'
DETECTION During execution.
CAUSE The CNC has tried to include (#CALL / #SET) a parked axis between the first three
axes of the channel.
SOLUTION A parked axis cannot be part of the first of three axes of the channel; unpark the axis
(#UNPARK).
1434 'An associated slave axis could not be included in the configuration'
DETECTION During execution.
CAUSE The CNC has tried to include the master axis of an active coupling or that of a Gantry
pair in the channel configuration (#CALL or #SET). When including the master axis,
the CNC also includes the slave axis which can never occupy one of the main three
positions of the channel. The CNC issues an error because there is no free position
other than the main three axis.
SOLUTION In order to only include the master axis, the active coupling must be deactivated first
(#UNLINK) or undo the Gantry pair. In order to include both the master and the slave
axis, first eliminate another axis from the channel or increase the number of axes of
the channel.
1435 'An associated slave axis could not be assigned a name because it was repeated'
DETECTION During execution.
CAUSE The CNC has tried to include the master axis of an active coupling or that of a Gantry
pair in the channel configuration (#CALL or #SET). When including the master axis,
the CNC also includes the slave axis which can never occupy one of the main three
positions of the channel. The CNC issues an error because the name of the slave
axis is already occupied by another axis of the current configuration of the channel.
SOLUTION Rename either the slave axis to be included or the one that already exists in the
configuration.
1436 'The stop block has not been programmed in the block search'
DETECTION During execution.
CAUSE The stop block of the block search is missing.
SOLUTION Once the block search option has been selected, the softkey menu shows the option
to select the stop block. Select the block where the block search will end.
1439 'The axes of the active transformation cannot be Hirth'
DETECTION During execution.
CAUSE The CNC has tried to activate a coordinate transformation (#TLC, #RTCP, #TOOL
ORI, #CS or #ACS), but one of the axes involved in the transformation is a Hirth axis.
SOLUTION A hirth axis must not be part of the coordinate transformation. An axis involved in the
transformation must not be a Hirth axis (G170).
To Next Page
Loading...
