Error solving manual.
CNC 8060
CNC 8065
·54·
(REF: 1709)
1440 'Wrong tool or edge'
DETECTION During execution.
CAUSE The tool and/or offset indicated in the variable does not exist.
SOLUTION Check the program. Check the existing tools and tool offsets.
1441 'The kinematics has not been activated'
DETECTION On CNC power-up or when validating the machine parameters.
CAUSE The kinematics that the CNC applies by default (parameter KINID) is unknown or the
axes required for the kinematics are not the right ones.
SOLUTION Check that the type of kinematics is correct and that the axes involved in it are properly
defined and belong to the channel. The axes must always be the first ones of the
channel, they must not be Hirth, they must not be parked and they must not be slaves
of a coupling or a gantry pair.
1442 'The kinematics has been deactivated'
DETECTION After a reset of the CNC or when starting the execution of a part-program.
CAUSE The CNC has canceled a kinematics, either because it is an unknown kinematics or
because the axes required for that kinematics are not the right ones.
SOLUTION Check that the type of kinematics is correct and that the axes involved in it are properly
defined and belong to the channel. The axes must always be the first ones of the
channel, they must not be Hirth, they must not be parked and they must not be slaves
of a coupling or a gantry pair.
1443 '#CS/ACS has been deactivated'
DETECTION After a reset of the CNC, when starting the execution of a part-program or during
home search.
CAUSE The axes used in the inclined plane are not the right ones. The CNC has tried to carry
out a home search while function #CS/ACS was active.
SOLUTION To make an inclined plane, the first three axes of the channel must be defined, linear,
unparked and not slaves of a coupling or a gantry pair. Deactivate the #CS/ACS
functions before searching home.
1444 'The main axes of the transformation must be linear'
DETECTION During execution.
CAUSE One of the main three axes involved in the programmed transformation or kinematics
is neither a linear axis.
SOLUTION The first three axes of the transformation or kinematics must be linear (parameter
AXISTYPE).
1445 'Wrong parameter value'
DETECTION During execution.
CAUSE A parameter has an invalid value in an instruction or a fixed cycle.
SOLUTION Check the program.
1446 'Starting block not allowed in a local subroutine'
DETECTION During execution.
CAUSE The starting block cannot be a block of a local subroutine.
SOLUTION Select another starting block.
1447 'Software option not allowed'
DETECTION During execution.
CAUSE The CNC does not have the software option required to execute the programmed
command.
SOLUTION In diagnosis mode, it is possible to check the software options offered by the CNC.
1448 'The tool cannot be placed perpendicular to the active plane'
DETECTION During execution.
CAUSE The possible causes are:
• The spindle type does not allow positioning the tool perpendicular to the plane,
as it may be the case of angular spindles.
• Placing the tool perpendicular to the active plane implies exceeding the limits.
SOLUTION Define another plane or position the tool in another point. Use another spindle, if
possible.
To Next Page
Loading...
