Error solving manual.
CNC 8060
CNC 8065
·56·
(REF: 1709)
1459 '#POLY: Wrong starting point'
DETECTION During execution.
CAUSE The starting point of the polynomial is not the same as the current position.
SOLUTION Modify the independent term of the polynomial for each axis making the starting point
of the polynomial the same as the end position of the previous block.
1461 'G9: The arc's intermediate point has been programmed wrong'
DETECTION During execution.
CAUSE One or both coordinates of the arc's intermediate point have not been programmed.
SOLUTION Function G9 requires the programming of both coordinates of the arc's intermediate
point.
1462 'G8: the tangent path cannot be calculated'
DETECTION During execution.
CAUSE An arc tangent to the previous path cannot be done with the programmed radius and
end point.
SOLUTION Check the program.
1463 'G9: Circular path programmed wrong'
DETECTION During execution.
CAUSE No arc can go through those three points.
SOLUTION Define two points in the block with a G9, that define an arc with the end point of the
previous movement. Bear in mind that all three points must be different and cannot
be in line.
1464 'Programmed rotary axis out of the range of the module'
DETECTION During execution.
CAUSE The absolute coordinate (G90) programmed for the MODULE type rotary axis is
wrong.
SOLUTION The coordinate programmed for the axis must be between the limits set by its machine
parameters MODUPLIM and MODLOWLIM.
1465 'Functions RTCP and TLC are incompatible with each other'
DETECTION During execution.
CAUSE The CNC has tried to activate one of the functions while the other one was active.
SOLUTION Both functions cannot be active at the same time.
1466 'G8 cannot be programmed as second motion block for G36/G37/G38/G39'
DETECTION During execution.
CAUSE A G8 block cannot be the second motion block of one of the functions
G36/G37/G38/G39. On one hand, these functions do not have an intermediate block
to make the path joining two blocks and, on the other hand, function G8 does not have
a previous block to be tangent to.
SOLUTION The second motion block of a G36/G37/G38/G39 function must be G0/G1/G2/G3.
1467 'POSLIMIT/NEGLIMIT cannot exceed the value of the machine parameter'
DETECTION During execution.
CAUSE The value to be written in variables V.A.POSLIMIT.xn and V.A.NEGLIMIT.xn cannot
exceed the value of machine parameters POSLIMIT and NEGLIMIT for that axis.
SOLUTION Check the program.
1468 'G30: Polar origin programmed wrong'
DETECTION During execution.
CAUSE One of the two coordinates of the Polar origin is missing in the G30 function.
SOLUTION Check the program. The coordinates of the Polar origin must be programmed in both
main axes.
1469 'Negative or zero radius not allowed'
DETECTION During execution.
CAUSE In a movement in Polar coordinates, the Polar radius is negative or zero.
SOLUTION The Polar radius must always be greater than zero. When programming with
incremental coordinates, the programmed value may be negative or zero, but not the
absolute Polar radius.
To Next Page
Loading...
