Error solving manual.
CNC 8060
CNC 8065
·57·
(REF: 1709)
1470 'UNIDIR rotary axis programmed wrong in incremental mode'
DETECTION During execution.
CAUSE The incremental coordinate programmed for the unidirectional rotary axis (parameter
UNIDIR) is wrong.
SOLUTION If machine parameter UNIDIR of the rotary axis is POSITIVE, the incremental
coordinate must be programmed with a positive or zero value. If machine parameter
UNIDIR of the rotary axis is NEGATIVE, the incremental coordinate must be
programmed with a negative or zero value.
1471 'G73: Rotation center programmed wrong'
DETECTION During execution.
CAUSE One of the two coordinates of the center of rotation is missing in the G73 function.
SOLUTION Check the program. The coordinates of the rotation center must be programmed in
both main axes.
1472 'G73: The rotation angle has not been programmed'
DETECTION During execution.
CAUSE The rotation angle has not been programmed in function G73.
SOLUTION Check the program. The coordinate system rotation angle must be programmed
together with the coordinates of the rotation center in both main axes.
1473 '#POLY cannot be programmed while pattern rotation is active'
DETECTION During execution.
CAUSE The CNC has tried to execute the #POLY instruction while a coordinate system
rotation (G73) was active.
SOLUTION Check the program.
1475 'Radius programmed twice'
DETECTION During execution.
CAUSE The radius ("R" or "R1") has been programmed more than one in the same block.
SOLUTION Define only one radius in the block.
1476 'The pocket was resolved with a different tool nose (tip) radius'
DETECTION During execution.
CAUSE The CNC generated the pocket with a tool radius other than the current one.
SOLUTION Generate the pocket again.
1477 'The pocket was resolved with a different tool's cutting length'
DETECTION During execution.
CAUSE The CNC generated the pocket with a tool's cutting length other than the current one.
SOLUTION Generate the pocket again.
1478 'The pocket was resolved with a different tool entry angle'
DETECTION During execution.
CAUSE The CNC generated the pocket with a tool entry angle other than the current one.
SOLUTION Generate the pocket again.
1479 'G74: A subroutine has not been associated'
DETECTION During execution.
CAUSE A G74 function has been programmed alone in the block, but the associated
subroutine does not exist.
SOLUTION Together with function G74, program the axes to be homed or define the associated
subroutine (parameter REFPSUB).
1480 'Program: #EXEC ["path+program",channel]'
DETECTION During execution.
CAUSE The syntax of the instruction is wrong or there is more data in the block.
SOLUTION Check the program. The instructions must be programmed alone in the block, only
the block label may be added.
1481 'Wrong channel number'
DETECTION During execution.
CAUSE Wrong channel number in the instruction #EXEC, #MEET or #WAIT.
SOLUTION The channel number must be between 1 and 4.
To Next Page
Loading...
