9
UNPACKING
2.1.
ASSEMBLY AND CONNECTION TO MAINS ELECTRICITY
2.2.
1. Cut the plastic film covering the package.
2. Carefully remove all the oven’s protective elements: top cover, edge protection
and polystyrene base.
To protect the environment, please follow the advice given in the part entitled
“Environmental Note”.
1. The measurements of the unit into which the
oven is to be mounted must coincide with those
indicated in the diagrams, depending on
whether the unit is wall-mounted or floor-based.
2. ASSEMBLY AND INSTALLATION
-Figure 1-
To Next Page
Loading...
