26
INSTALLATION
3
Place the hob alongside the cavity in
the worktop and connect the power
cable to the electrical socket.
IMPORTANT: Carry out connection
with the power disconnected.There
must be a good grounding connection
and a switch must be provided in an
accessible place to isolate all phases,
with at least 3mm. clearance between
contacts. The makers will not accept responsability
for installations carried out other than as directed
here.
It is equipped with a power input cable for high
temperatures.
If a new power input cable is required, installation
should be performed by a technician certificated by
the maker.
4
Next insert the hob in the worktop
cavity, pressing down firmly to ensure a
good seal.
5
NOTE: This equipment complies with satnadard 82/499/CE on radio interferences.
Fix the 4 clamps underneath the hob to
the 4 corners of the cavity.
(Clamps, brackets and nuts supplied in
acessory bag).
To Next Page
Loading...
