37
EN
ATTENTION!
When you are making cappuccino, latte or hot milk, adjust the milk foam dispensation
tube to the cup to be used by using the handle of the milk foam dispensation tube.
Danger of Burn!
After making a milky drink, do not touch the milk foam dispensation tube as it will be too
hot or wait for it to cool down or use the dispensation tube handle.
Use of The Appliance
Before using the appliance for the rst time;
• Place the appliance on a fast surface and hard ground, minimum 3 cm space between the
surfaces of the appliance and the side and rear walls and make sure there is at least 15
cm of free space above the coffee machine.
• Make sure all symbols are off by turning off the power switch on the side of the unit.
• Disconnect the plug from the electrical outlet.
• Remove the labels and packaging elements from the appliance.
• Remove the water tank, milk chamber, and all lters. Wash all the chambers, scale
spoons/ tamping and lters with warm water or use special detergents for coffee
machines. Rinse each well thoroughly and then dry. Then install each back into the
appliance.
Operating the Appliance
Before each rst use;
• Fill the water tank between the “Min” and “Max” levels.
• Fill the milk chamber between the “Min” and “Max” levels.
• Select one of the lters and place them in the lter holder. Place the lter holder on the
appliance.
• Make sure that it is properly locked and place a cup under it. Also place the milk dispenser
tube into the glass.
• Plug the appliance into the appropriate electrical outlet.
• Turn on the power switch; all symbols blink 3 times with beep.
• When all symbols are steadily lit, press the
symbol. The appliance will start and the
other symbols will turn off.
• When this process is complete, all symbols will light up again.
• Your unit is now prepared and ready to use.
To Next Page
Loading...
